Tutorials

In short, the localisation consists of the following steps:

1. Note in which CBs the FRB was detected.

2. Save a snippet for the detection CBs, as well as for all surrounding CBs.

3. Create a configuration file with the settings to use to S/N determination

4. Run arts_calc_snr

5. Add localisation settings to the configuration file, using coarse resolution

6. Run arts_run_localisation

7. Repeat the previous step with different settings until the entire uncertainty region is covered

8. Re-run the localisation at high resolution

The below tutorials go through these steps with examples:

• Repeater localisation
• One-off drift scan localisation